CVE-2026-99751

UNRATEDCVSS · not yet scored

Also known asEUVD-2026-130867 (ENISA EUVD) · GHSA-cfq2-9x4r-2cfp (GitHub Security Advisories)Source: ENISA EUVD

—
EchelonGraph verdictMonitorLow exploitation likelihood right now — keep watching.
  • No CVSS published and no exploitation signals yet
CISA-KEV: Not listedEPSS PROB: 0.2%CVSS v2: —Exploit: None knownExposed services: Not assessed

A fix is available — apply it.

In the Linux kernel, the following vulnerability has been resolved:

bpf: Fix skb_pull() BUG in __bpf_redirect_neigh()

The issue: This is a follow-up to the short link-layer header fixes from Eric. After vlan pop_eth, a privileged SCHED_ACT BPF program can call bpf_skb_change_head(skb, 1, 0) and then bpf_redirect_neigh().

__bpf_redirect_neigh() calls skb_pull(skb, sizeof(*ethh)) after checking only that mac_header < network_header. Nothing verifies that the MAC header is long enough, that it is linear, or that the IP header the redirect goes on to read is linear either.

A SCHED_ACT BPF program can do:

bpf_skb_change_head(skb, 1, 0); bpf_redirect_neigh(lo, NULL, 0, 0);

after vlan pop_eth. The skb then has mac_len == 1 and only one byte of linear data; skb_pull(ETH_HLEN) trips the skb->len < skb->data_len BUG in __skb_pull():

kernel BUG at ./include/linux/skbuff.h:2839! RIP: skb_pull+0x40/0x50 Call Trace: skb_do_redirect -> packet_xmit -> packet_sendmsg Kernel panic - not syncing: Fatal exception in interrupt

The v4 and v6 paths read ip_hdr() and ipv6_hdr() as soon as the MAC header is gone. On the AF_PACKET frame below that leaves headlen == 0 after the pull, so the network header sits at skb->tail and the route lookup reads ip4h->protocol, ip4h->saddr and ip4h->daddr past the linear area.

The Fix: Use skb_network_offset(), which is the MAC header span, instead of skb->mac_len. mac_len is zero for locally generated tc egress and netkit packets, while the span still rejects the one-byte header produced by pop_eth + bpf_skb_change_head(skb, 1, 0). The single check also covers the mac_header >= network_header test it replaces.

Use pskb_may_pull() to make the Ethernet header linear before it is read or pulled, and to make the IP header linear in both the v4 and the v6 path before ip_hdr()/ipv6_hdr() is read. The header pointers are taken after the pull, since pskb_may_pull() may reallocate skb->head.

Conditions to recreate the bug: On x86-64 with 4 KiB pages, enable CONFIG_PACKET, CONFIG_BPF_SYSCALL, CONFIG_NET_SCH_INGRESS, CONFIG_NET_CLS_MATCHALL, CONFIG_NET_ACT_VLAN and CONFIG_NET_ACT_BPF. Run as root with BPF loading, network administration and raw-packet privileges. Bring lo up and attach a SCHED_ACT program that calls bpf_skb_change_head(skb, 1, 0), then returns bpf_redirect_neigh(skb->ifindex, NULL, 0, 0):

ip link set lo up tc qdisc add dev lo clsact tc filter add dev lo egress matchall action vlan pop_eth pipe \ action bpf object-file neigh_chghead.o section action

Send an untagged ETH_P_IP frame of ETH_HLEN + 8192 bytes through an AF_PACKET/SOCK_RAW socket bound to lo, without PACKET_VNET_HDR or PACKET_QDISC_BYPASS. Use a unicast destination MAC. The sender's skb has a 14-byte linear Ethernet prefix and a fragmented payload; pop_eth removes that prefix and change_head restores only one linear byte. The unfixed neighbor redirect then tries to pull 14 bytes and BUGs.

Sending the same frame without pop_eth and change_head leaves the IP header in the frags, which is the route lookup reading past skb->tail.

CVSS
—
EchelonGraph score
Not yet assessedNo source has published severity data for this CVE yet — no CVSS score from NVD or a CNA, no GitHub advisory, and it is not in CISA KEV. This is not a rating of zero; we cannot assess it yet.
EG Score
—
EG Risk
—
EPSS PROB
0.2%
EPSS %ILE
7th
KEV
Not listed

What the EG score is made of (scorer v4.0: the three questions the 0–10 score mixes, published apart · methodology)

EG Severity
Not assessed: no CVSS publishedA missing CVSS is not a severity of zero.
EG Likelihood
0.2% within 30 daysSource: FIRST EPSS. FIRST's exploitation probability, not an EchelonGraph model.
Confirmed exploitation
None on record (CISA KEV, EG-KEV Tier 1)Reported apart from the likelihood: an observed fact, not a probability.
EG Priority
No SSVC decision: EchelonGraph has not assessed this CVECISA BOD 26-04: 14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.Each input and its source, and whom BOD 26-04 binds: the BOD 26-04 block below.

BOD 26-04 (CISA's remediation timeline, Table 1)14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.

The score's inputs: In CISA KEV no (CISA's KEV catalog) · Automatable no (CISA's BOD 26-04 default) · Technical impact total (CISA's BOD 26-04 default). Where an input reads “CISA's BOD 26-04 default”, no one has published it for this CVE, and CISA's implementation guidance says: “If “Automatable” and “Technical Impact” information items about a CVE ID are not available and the CVE ID is not in the KEV Catalog, CISA will treat its values as “no” and “total,” respectively, until CISA or a third party provides metadata about the CVE ID. CISA will always provide the Vulnrichment data for a CVE ID listed in the KEV Catalog.” Whether your system is publicly exposed is yours to answer. BOD 26-04 binds US Federal Civilian Executive Branch agencies; for anyone else it is CISA's published timeline, a reference rather than an obligation. The directive · how EchelonGraph applies it

Published

November 20, 2026

Last Modified

November 20, 2026

Vendor Advisories for CVE-2026-99751(2)

These vendors published their own advisory mentioning this CVE — often with vendor-specific remediation steps + affected product lists not in NVD.

Data Freshness Timeline

(refreshed 5× in last 7d / 5× in last 30d)

Each row is a time one of our pipelines fetched, updated or re-scored this CVE. For example, "NVD update" means NVD published or revised its analysis for this CVE; "MITRE cvelistV5" means we ingested or refreshed its CVE.org record (CNA or CISA ADP). An arrow marks a change the record states ("CVSS → 9.1"); EPSS and GHSA rows show the values recorded at that time, not what changed (EPSS values are rounded; hover one for the exact figures). "EchelonGraph re-scored" is our own recompute of this CVE's score, not an update from a source, and is not counted in the refreshes above. Most recent first.

  1. 2026-11-21 16:42 UTCEPSS rescoreEPSS 0.2% · 7th percentile
  2. 2026-11-20 16:39 UTCEPSS rescoreEPSS 0.2% · 7th percentile
  3. 2026-11-20 08:06 UTCGHSA enrichmentGHSA-cfq2-9x4r-2cfp
  4. 2026-11-20 07:03 UTCENISA EUVD ID recordedEUVD-2026-130867 · Source: ENISA EUVD
  5. 2026-11-20 05:58 UTCEchelonGraph re-scored
  6. 2026-11-20 05:57 UTCMITRE cvelistV5first tracked

Frequently asked(4)

What is CVE-2026-99751?
CVE-2026-99751 is a vulnerability whose severity is not yet rated; its CVE record was published on November 20, 2026. In the Linux kernel, the following vulnerability has been resolved: bpf: Fix skb_pull() BUG in __bpf_redirect_neigh() The issue: This is a follow-up to the short link-layer header fixes from Eric. After vlan pop_eth, a privileged SCHED_ACT BPF program can call bpf_skb_change_head(skb, 1, 0) and…
When was the CVE record for CVE-2026-99751 published?
The CVE record for CVE-2026-99751 was published on November 20, 2026. That is the record's publication date; the vulnerability itself may have been made public earlier. EchelonGraph's copy of the record carries a last-modified date of November 20, 2026; the record at its source may have been updated since.
Is CVE-2026-99751 actively exploited?
CVE-2026-99751 is not currently on CISA's Known Exploited Vulnerabilities catalog. FIRST EPSS estimates a 0.2% probability of exploitation in the next 30 days (7th percentile of EPSS-scored CVEs).
How do I remediate CVE-2026-99751?
A fix for CVE-2026-99751 is available: update to the fixed version the vendor names in its advisory. The vendor advisories EchelonGraph has for CVE-2026-99751 are linked in the Vendor Advisories panel on this page.

Dependency Blast Radius

Explore the affected products and dependency analysis for CVE-2026-99751

Explore →

Is Your Infrastructure Affected by CVE-2026-99751?

EchelonGraph automatically scans your cloud infrastructure and maps CVE exposure using blast radius analysis.