In the Linux kernel, the following vulnerability has been resolved:
mm/shmem: fix accounting of swapin-error markers
A failed swap read replaces the swap entry with a swapin-error marker in
the page-cache and subtracts its pages from "alloced" and "swapped";
however, it leaves their block charge in place.
Removing the marker during truncate then subtracts from "swapped" again.
This can underflow the counters or make swapped reach zero while other
pages remain swapped out, causing swapoff to loop without finding them.
When installing the marker, subtract only from "swapped" and let
shmem_recalc_inode() reduce "alloced" and release the block charge.
Make shmem_free_swap() report successful removal separately from the
number of swap pages freed, so removing a swapin-error marker does not
subtract from "swapped" again.
It's a bit confusing, but replacing a swapped out page by a swapin-error
marker in shmem_set_folio_swapin_error() behaves as follows:
Initially:
alloced=1, swapped=1, nrpages=0
Calling shmem_recalc_inode(inode, 0, -1)
-> swapped = 0
-> freed = 1 - 0 - 0 = 1
-> alloced -= freed
-> alloced=0, swapped=0, block charge released
What the EG score is made of (scorer v4.0: the three questions the 0–10 score mixes, published apart · methodology)
- EG Severity
- Not assessed: no CVSS publishedA missing CVSS is not a severity of zero.
- EG Likelihood
- 0.2% within 30 daysSource: FIRST EPSS. FIRST's exploitation probability, not an EchelonGraph model.
- Confirmed exploitation
- None on record (CISA KEV, EG-KEV Tier 1)Reported apart from the likelihood: an observed fact, not a probability.
- EG Priority
- No SSVC decision: EchelonGraph has not assessed this CVECISA BOD 26-04: 14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.Each input and its source, and whom BOD 26-04 binds: the BOD 26-04 block below.
BOD 26-04 (CISA's remediation timeline, Table 1)14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.
The score's inputs: In CISA KEV no (CISA's KEV catalog) · Automatable no (CISA's BOD 26-04 default) · Technical impact total (CISA's BOD 26-04 default). Where an input reads “CISA's BOD 26-04 default”, no one has published it for this CVE, and CISA's implementation guidance says: “If “Automatable” and “Technical Impact” information items about a CVE ID are not available and the CVE ID is not in the KEV Catalog, CISA will treat its values as “no” and “total,” respectively, until CISA or a third party provides metadata about the CVE ID. CISA will always provide the Vulnrichment data for a CVE ID listed in the KEV Catalog.” Whether your system is publicly exposed is yours to answer. BOD 26-04 binds US Federal Civilian Executive Branch agencies; for anyone else it is CISA's published timeline, a reference rather than an obligation. The directive · how EchelonGraph applies it