In the Linux kernel, the following vulnerability has been resolved:
mm/hugetlb_vmemmap: map the shared tail page writable
page_ref_add_unless_zero() reads the refcount and then updates it with a
cmpxchg. A lockless get, such as a page cache lookup or a PFN scanner,
can read a non-zero refcount from a page that is then freed and reused as
a hugetlb tail page. If HVO remaps its struct page to the shared tail
page in between, the cmpxchg writes to read-only vmemmap:
CPU0 (lockless get) CPU1
c = atomic_read(&page->_refcount)
page freed
page allocated as a hugetlb tail
HVO remaps the struct page RO
try_cmpxchg(&page->_refcount, &c, c + 1)
-> write fault on read-only vmemmap
The refcount is zero by then and the compare fails, but a compare-and-swap
instruction needs write access whether or not it succeeds. The kernel
oopses when hugetlb pages are allocated at runtime with HVO enabled while
a lockless get races with it.
Commit bd225530a4c7 ("mm/hugetlb_vmemmap: fix race with speculative PFN
walkers") closed the window with RCU on both sides. The RCU was removed
together with fake heads, on the wrong belief that it was only needed for
them.
Map the shared tail page writable instead of restoring the RCU. Every
struct page on it is a tail with a zero refcount, so a late cmpxchg
fails and leaves the page unchanged. RCU would put rcu_read_lock()
back around every get and synchronize_rcu() back into hugetlb
allocation and freeing.
The cost is the protection against stray writes to tail struct pages. The
shared page is shared by all hugetlb folios of the same order in the zone,
so such a write now corrupts all of them instead of oopsing.
Bootmem folios optimized when the memmap is set up keep their tails
read-only. Nothing does a lockless get on them before hugetlb takes them
over.
What the EG score is made of (scorer v4.0: the three questions the 0–10 score mixes, published apart · methodology)
- EG Severity
- Not assessed: no CVSS publishedA missing CVSS is not a severity of zero.
- EG Likelihood
- 0.2% within 30 daysSource: FIRST EPSS. FIRST's exploitation probability, not an EchelonGraph model.
- Confirmed exploitation
- None on record (CISA KEV, EG-KEV Tier 1)Reported apart from the likelihood: an observed fact, not a probability.
- EG Priority
- No SSVC decision: EchelonGraph has not assessed this CVECISA BOD 26-04: 14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.No released fix is confirmed on this page, but CISA's timeline does not wait for a fix's release: it starts when an agency identifies the flaw on an asset and updates the CDM Agency and Federal Dashboard, and the directive counts patching, decommissioning the system or another action as remediation. Until a fixed release is applied, mitigate as this page's verdict says. In the directive's words, “Fix on system upgrade” means that, “unless conditions change”, the vulnerability “should be remediated the next time the vulnerable asset receives a scheduled major upgrade or rebuild”: its timelines are “dynamic as facts change”, and a KEV listing shortens them.Each input and its source, and whom BOD 26-04 binds: the BOD 26-04 block below.
BOD 26-04 (CISA's remediation timeline, Table 1)14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.
No released fix is confirmed on this page, but CISA's timeline does not wait for a fix's release: it starts when an agency identifies the flaw on an asset and updates the CDM Agency and Federal Dashboard, and the directive counts patching, decommissioning the system or another action as remediation. Until a fixed release is applied, mitigate as this page's verdict says. In the directive's words, “Fix on system upgrade” means that, “unless conditions change”, the vulnerability “should be remediated the next time the vulnerable asset receives a scheduled major upgrade or rebuild”: its timelines are “dynamic as facts change”, and a KEV listing shortens them.
The score's inputs: In CISA KEV no (CISA's KEV catalog) · Automatable no (CISA's BOD 26-04 default) · Technical impact total (CISA's BOD 26-04 default). Where an input reads “CISA's BOD 26-04 default”, no one has published it for this CVE, and CISA's implementation guidance says: “If “Automatable” and “Technical Impact” information items about a CVE ID are not available and the CVE ID is not in the KEV Catalog, CISA will treat its values as “no” and “total,” respectively, until CISA or a third party provides metadata about the CVE ID. CISA will always provide the Vulnrichment data for a CVE ID listed in the KEV Catalog.” Whether your system is publicly exposed is yours to answer. BOD 26-04 binds US Federal Civilian Executive Branch agencies; for anyone else it is CISA's published timeline, a reference rather than an obligation. The directive · how EchelonGraph applies it