CVE-2026-99693

UNRATEDCVSS · not yet scored

Also known asEUVD-2026-130986 (ENISA EUVD) · GHSA-ffm3-wggj-jxvj (GitHub Security Advisories)Source: ENISA EUVD

—
EchelonGraph verdictMonitorLow exploitation likelihood right now — keep watching.
  • No CVSS published and no exploitation signals yet
CISA-KEV: Not listedEPSS PROB: 0.2%CVSS v2: —Exploit: None knownExposed services: Not assessed

A fix is available — apply it.

In the Linux kernel, the following vulnerability has been resolved:

ocfs2/dlm: serialize migration MLE cleanup on failure

A migration MLE has a base reference for the mastering answer and an in-use reference held by dlm_migrate_lockres(). The finishing assertion consumes the base reference, but migration failure drops it again without checking whether the assertion already consumed it.

The target queues its migration worker before it acknowledges the ALL_DONE packet, so its finishing assertion can be handled while the sender still waits for the status. If the connection fails before the status arrives, dlm_send_one_lockres() returns an error for a migration that the target has already completed:

Old-master sender Finishing assertion ----------------- ------------------- publish MLE; take in-use reference send ALL_DONE; wait for status take lookup reference unlink MLE put lookup and base references send returns a connection error put base reference again; free MLE put in-use reference; access freed MLE

dlm_assert_master_handler() holds dlm->spinlock from the MLE lookup to the final puts, and it takes dlm->master_lock around the unlink and the puts. Decide under the same locks: if the MLE is already unhashed, the assertion consumed the base reference, so drop only the sender's in-use reference. Otherwise unlink it before consuming the base reference so a later assertion no longer finds it.

An assertion that got there first has also made the target the owner and cleared DLM_LOCK_RES_MIGRATING. Treating the attempt as failed at that point would leave the lockres owned by the target while this node still holds the other nodes' locks and refmap bits, so it could neither be purged nor migrated again. Finish our side as a completed migration does instead: drop those locks under res->spinlock if the target still owns the lockres, and recalculate its usage.

Use the same cleanup for the pre-send failure, the send failure and the target-death failure paths. The sender's in-use reference keeps the MLE alive until its final put outside the nested locks. Successful migration retains its existing in-use-only put.

A target that has died cannot assert after the sender has seen its death. The o2net node-down callback runs before the DLM one; it disconnects the node and flushes the workqueue that runs the message handlers, so an assertion already received has been handled by the time the DLM removes the node from the domain map. A node that leaves the domain cleanly sends its exit message only after its assertions have been answered.

Two windows of the hand-over itself are left as they are: the handler switches the owner and the sender drops the other nodes' locks moments later, and an assertion from a live target that arrives after the sender has given up still meets the owner check in the handler. Waiting for the target before giving up would only stretch the first window into the time in which recovery of the target can observe it.

KASAN report, only the relevant frames are kept:

BUG: KASAN: slab-use-after-free in dlm_put_mle_inuse+0xce/0xe0 Read of size 8 at addr ffff8881190e3c20 by task umount/593

Call Trace: dlm_put_mle_inuse+0xce/0xe0 dlm_migrate_lockres+0x16af/0x20d0 dlm_empty_lockres+0x60a/0xbd0 dlm_unregister_domain+0x53b/0x11d0 o2cb_cluster_disconnect+0xa5/0x110 ocfs2_cluster_disconnect+0x73/0xc0 ocfs2_dlm_shutdown+0x311/0x440 ocfs2_dismount_volume+0x696/0x940 generic_shutdown_super+0x15f/0x490 kill_block_super+0x40/0xa0 deactivate_locked_super+0xae/0x120 deactivate_super+0xa2/0xc0 cleanup_mnt+0x217/0x450 task_work_run+0x144/0x230

Allocated by task 593: kmem_cache_alloc_noprof+0x20b/0x5c0 dlm_migrate_lockres+0x20e/0x20d0 dlm_empty_lockres+0x60a/0xbd0 dlm_unregister_domain+0x53b/0x11d0 o2cb_cluster_disconnect+0xa5/ ---truncated---

CVSS
—
EchelonGraph score
Not yet assessedNo source has published severity data for this CVE yet — no CVSS score from NVD or a CNA, no GitHub advisory, and it is not in CISA KEV. This is not a rating of zero; we cannot assess it yet.
EG Score
—
EG Risk
—
EPSS PROB
0.2%
EPSS %ILE
6th
KEV
Not listed

What the EG score is made of (scorer v4.0: the three questions the 0–10 score mixes, published apart · methodology)

EG Severity
Not assessed: no CVSS publishedA missing CVSS is not a severity of zero.
EG Likelihood
0.2% within 30 daysSource: FIRST EPSS. FIRST's exploitation probability, not an EchelonGraph model.
Confirmed exploitation
None on record (CISA KEV, EG-KEV Tier 1)Reported apart from the likelihood: an observed fact, not a probability.
EG Priority
No SSVC decision: EchelonGraph has not assessed this CVECISA BOD 26-04: 14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.Each input and its source, and whom BOD 26-04 binds: the BOD 26-04 block below.

BOD 26-04 (CISA's remediation timeline, Table 1)14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.

The score's inputs: In CISA KEV no (CISA's KEV catalog) · Automatable no (CISA's BOD 26-04 default) · Technical impact total (CISA's BOD 26-04 default). Where an input reads “CISA's BOD 26-04 default”, no one has published it for this CVE, and CISA's implementation guidance says: “If “Automatable” and “Technical Impact” information items about a CVE ID are not available and the CVE ID is not in the KEV Catalog, CISA will treat its values as “no” and “total,” respectively, until CISA or a third party provides metadata about the CVE ID. CISA will always provide the Vulnrichment data for a CVE ID listed in the KEV Catalog.” Whether your system is publicly exposed is yours to answer. BOD 26-04 binds US Federal Civilian Executive Branch agencies; for anyone else it is CISA's published timeline, a reference rather than an obligation. The directive · how EchelonGraph applies it

Published

November 20, 2026

Last Modified

November 20, 2026

Vendor Advisories for CVE-2026-99693(2)

These vendors published their own advisory mentioning this CVE — often with vendor-specific remediation steps + affected product lists not in NVD.

Data Freshness Timeline

(refreshed 5× in last 7d / 5× in last 30d)

Each row is a time one of our pipelines fetched, updated or re-scored this CVE. For example, "NVD update" means NVD published or revised its analysis for this CVE; "MITRE cvelistV5" means we ingested or refreshed its CVE.org record (CNA or CISA ADP). An arrow marks a change the record states ("CVSS → 9.1"); EPSS and GHSA rows show the values recorded at that time, not what changed (EPSS values are rounded; hover one for the exact figures). "EchelonGraph re-scored" is our own recompute of this CVE's score, not an update from a source, and is not counted in the refreshes above. Most recent first.

  1. 2026-11-21 16:42 UTCEPSS rescoreEPSS 0.2% · 6th percentile
  2. 2026-11-20 16:39 UTCEPSS rescoreEPSS 0.2% · 6th percentile
  3. 2026-11-20 08:12 UTCGHSA enrichmentGHSA-ffm3-wggj-jxvj
  4. 2026-11-20 07:04 UTCENISA EUVD ID recordedEUVD-2026-130986 · Source: ENISA EUVD
  5. 2026-11-20 05:58 UTCEchelonGraph re-scored
  6. 2026-11-20 05:57 UTCMITRE cvelistV5first tracked

Frequently asked(4)

What is CVE-2026-99693?
CVE-2026-99693 is a vulnerability whose severity is not yet rated; its CVE record was published on November 20, 2026. In the Linux kernel, the following vulnerability has been resolved: ocfs2/dlm: serialize migration MLE cleanup on failure A migration MLE has a base reference for the mastering answer and an in-use reference held by dlm_migrate_lockres(). The finishing assertion consumes the base reference, but…
When was the CVE record for CVE-2026-99693 published?
The CVE record for CVE-2026-99693 was published on November 20, 2026. That is the record's publication date; the vulnerability itself may have been made public earlier. EchelonGraph's copy of the record carries a last-modified date of November 20, 2026; the record at its source may have been updated since.
Is CVE-2026-99693 actively exploited?
CVE-2026-99693 is not currently on CISA's Known Exploited Vulnerabilities catalog. FIRST EPSS estimates a 0.2% probability of exploitation in the next 30 days (6th percentile of EPSS-scored CVEs).
How do I remediate CVE-2026-99693?
A fix for CVE-2026-99693 is available: update to the fixed version the vendor names in its advisory. The vendor advisories EchelonGraph has for CVE-2026-99693 are linked in the Vendor Advisories panel on this page.

Dependency Blast Radius

Explore the affected products and dependency analysis for CVE-2026-99693

Explore →

Is Your Infrastructure Affected by CVE-2026-99693?

EchelonGraph automatically scans your cloud infrastructure and maps CVE exposure using blast radius analysis.