In the Linux kernel, the following vulnerability has been resolved:
cgroup: serialize migrations of newly forked processes
With favordynmods enabled, a cgroup.procs migration takes the target
threadgroup's cgroup_threadgroup_rwsem for writing. A process fork holds
the forking threadgroup's semaphore for reading. These are different
semaphores when fork creates a new process.
copy_process() publishes the child's PID before cgroup_post_fork() links
the child to its css_set. A writer can find the child in that interval,
take its uncontended semaphore, and migrate it while child->cgroups still
points to init_css_set and child->cg_list is empty. Migration links the
node into init_css_set.mg_tasks. cgroup_post_fork() then adds the same
node to the intended css_set as though it were unlinked, corrupting both
task lists and their css_set ownership.
This regresses the fork/migration race fixed by commit b12b533fa523
("cgroups: add lock for child->cgroups in cgroup_post_fork()") and
restored again in 2012 after the lock had been removed. The old task_lock
protection was later superseded by global css_set and cgroup threadgroup
locking. The change identified by the Fixes tag narrowed only the migration
side back to a per-threadgroup lock, recreating the different-process
exclusion failure.
Take the new threadgroup's semaphore for reading before the child becomes
visible and hold it through cgroup_post_fork(). Use a nested lock subclass
because fork already holds the parent's semaphore. CLONE_THREAD children
share the parent's signal_struct and remain covered by the existing lock.
Migrations of unrelated, fully initialized threadgroups remain concurrent.
An AI coding assistant was used to identify and reproduce the regression
and to develop and test this fix.
What the EG score is made of (scorer v4.0: the three questions the 0–10 score mixes, published apart · methodology)
- EG Severity
- Not assessed: no CVSS publishedA missing CVSS is not a severity of zero.
- EG Likelihood
- 0.2% within 30 daysSource: FIRST EPSS. FIRST's exploitation probability, not an EchelonGraph model.
- Confirmed exploitation
- None on record (CISA KEV, EG-KEV Tier 1)Reported apart from the likelihood: an observed fact, not a probability.
- EG Priority
- No SSVC decision: EchelonGraph has not assessed this CVECISA BOD 26-04: 14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.No released fix is confirmed on this page, but CISA's timeline does not wait for a fix's release: it starts when an agency identifies the flaw on an asset and updates the CDM Agency and Federal Dashboard, and the directive counts patching, decommissioning the system or another action as remediation. Until a fixed release is applied, mitigate as this page's verdict says. In the directive's words, “Fix on system upgrade” means that, “unless conditions change”, the vulnerability “should be remediated the next time the vulnerable asset receives a scheduled major upgrade or rebuild”: its timelines are “dynamic as facts change”, and a KEV listing shortens them.Each input and its source, and whom BOD 26-04 binds: the BOD 26-04 block below.
BOD 26-04 (CISA's remediation timeline, Table 1)14 days if the affected system is publicly exposed; Fix on system upgrade if it is not.
No released fix is confirmed on this page, but CISA's timeline does not wait for a fix's release: it starts when an agency identifies the flaw on an asset and updates the CDM Agency and Federal Dashboard, and the directive counts patching, decommissioning the system or another action as remediation. Until a fixed release is applied, mitigate as this page's verdict says. In the directive's words, “Fix on system upgrade” means that, “unless conditions change”, the vulnerability “should be remediated the next time the vulnerable asset receives a scheduled major upgrade or rebuild”: its timelines are “dynamic as facts change”, and a KEV listing shortens them.
The score's inputs: In CISA KEV no (CISA's KEV catalog) · Automatable no (CISA's BOD 26-04 default) · Technical impact total (CISA's BOD 26-04 default). Where an input reads “CISA's BOD 26-04 default”, no one has published it for this CVE, and CISA's implementation guidance says: “If “Automatable” and “Technical Impact” information items about a CVE ID are not available and the CVE ID is not in the KEV Catalog, CISA will treat its values as “no” and “total,” respectively, until CISA or a third party provides metadata about the CVE ID. CISA will always provide the Vulnrichment data for a CVE ID listed in the KEV Catalog.” Whether your system is publicly exposed is yours to answer. BOD 26-04 binds US Federal Civilian Executive Branch agencies; for anyone else it is CISA's published timeline, a reference rather than an obligation. The directive · how EchelonGraph applies it